86
Type 100/300 Operation and Installation Handbook
Trim Level
Trim Level sets the level for automatic trim which applies additional rudder
to correct for unbalanced propeller torque on twin engine installations, or
weather helm.
The Trim Level settings available are as follows (rate of trim increases with
trim level):
Range 0 to 4
Default setting 2 (Displacement)
3 (Semi displacement, planing and
stern drive)
Joystick Mode (Manual Type)
Power steer selects the Joystick mode of operation: Proportional or ‘Bang-
Bang’.
Proportional applies rudder in proportion to Joystick movement - the
further the Joystick is held over the greater the applied rudder.
Bang-Bang applies continous rudder drive in the direction of lever move-
ment. To improve control the speed of rudder movement changes with the
angle of the lever. For maximum speed push the lever hardover. If the lever
is returned to the center position the rudder will remain in its current
position.
The settings available are as follows:
Range 0
1
2
OFF
(Proportional)
(Bang-Bang)
Default setting 1
81004-25
Drive Option
Drive Option sets the type of drive used by your vessel: mechanical with
rudder reference or hydraulic with rudder reference.
The settings available are as follows:
Range 1 to 4
Default setting 1 Future use
2 Future use
3 (Displacement and stern drive)
4 (All hydraulic installations)
81004-26
To Next Page
Loading...
