66
TYPE 100/300 Operation and Installation Handbook
Cabling
IN
+ –
NMEA WINDVANE
SEATALKSEATALKALARM
OUT
+ –
D982-1
SeaTalk SeaTalk CLUTCH
+–
Grey (screen)
Red
Yellow
Connect the NMEA interface to the alarm and course computer as
shown.
2.10 Joystick
The mounting surface must be smooth and flat to ensure that there is
adequate waterproofing.
1. Use the template provided to mark the centers for the two fixing
holes and outline of the body aperture.
2. Drill the fixing holes and cut-out the aperture for the body.
3. Remove the mounting template and peel off the protective paper
from the rear of the weather gasket and fix to the mounting
surface.
4. Pass the signal cable through the body aperture and secure the
Joystick with the thumb nuts provided.
To Next Page
Loading...
