64
TYPE 100/300 Operation and Installation Handbook
Front cover
Lock nut
Fixing screw
D409-2
Cabling
1. Plug in the power cable, supplied with the drive unit, making sure
that the connector is locked in place by turning the locking ring
clockwise.
2. Run the cable back to the course computer. Secure the cable
close to the drive unit but allowing sufficient free length to
accommodate the drive unit movement.
3. Once again using the steering wheel to move the rudder from
hard over to hard over, check that the cable does not catch on
any part of the vessel/fittings.
4. The actuator cable has electrical connections for both the drive
motor and the clutch. Connect to the course computer terminals
To Next Page
Loading...
