92
TYPE 100/300 Operation and Installation Handbook
D919-1
Keep turning until the display changes to show the amount of deviation the
autopilot has corrected. This can take up to 2 full turns depending on the
amount of deviation found.
RUDDER
0
10
20
30
10
20
30
Cal.
Cal.
Cal.
ST7000
ST6000
D1019a-1
Note:
If the deviation exceeds 15 degrees, you should relocate the
fluxgate compass.
3. Steady the boat up on one heading and use the course change keys
to adjust the displayed heading until it agrees with the steering
compass or a known transit bearing.
4. To exit fluxgate alignment/correction and store the settings, push and
hold STANDBY for 2 seconds until the pilot returns to ‘STANDBY’
mode.
5. To exit fluxgate alignment/correction without saving any new settings,
push STANDBY momentarily.
To Next Page
Loading...
