.,.
,
_.._._
-_-__-
.
-’
-‘&PA’
_
-
~.
-_
_-
_-._
ST50
plus
Depth
Dperation
andlnstallation
Handbook
Chapter 6: Calibration
27
On
i;ower-Up
Chapter 6: Calibration
Action
Display Shows
1
Press and DEPTH and ALARM together for
CAL after 2 seconds and
As it leaves the factory the ST50
flus
Depth is set to dispfay depth
u&s
in
4 seconds
VER X.X after 4 seconds
feet. These settings, together and other navigational features, can be
2
Press DEPTH twice
CODELOCK
Cal. Off
changed (e.g., Feet to Metresjas described in this section.
3
4 seconds after
CODELOCK
Cal. Off
ENTER CODE
4
Press ALARM
I
I
-
- - -
5
Press OFFSET or RESET to select first
1 _ _ _
number
6
Press ALARM to accept number 1’~‘-
-
7 Press OFFSET or RESET to select second
1 2 _ _
number
a
Press ALARM to accept number
1 2’-‘-
9
Press OFFSET or RESET to select third
123-
number
10 Press ALARM to accept third number
1 2 3’-’
11 Press OFFSET or RESET to select fourth
1234
number
12 Press ALARM to accept code
‘1234
13 Press ALARM
PWR ON?
14 Press ALARM within 10 seconds
CODELOCK
Cal. set
15 To save code, press DEPTH and ALARM
Normal operation, eg.
together for 2 seconds
depth display
T11Zl
If you do not exit ‘CODELOCK Cal. set’ within 10 seconds, the display will
change to CANCEL CODE. You now have the option of cancelling the
code, by pressing
ALARM
to return to the __
_
_
display, or exit as
described in action 15 above.
Your Code Number
For future reference, enter your chosen code number in the following box.
For obvious reasons, please store this handbook in a safe place.
Operation
When the unit is powered on you are prompted to enter the code number.
To enter the number, carry out actions 4 to 12 and press
ALARM.