1.Checktheselectedlocationfortheunit.TheVCM100requiresaclear,flatareawithsuitable
spaceforroutingthecablesbelowtheunit.
2.HoldtheVCM100inplaceintherequiredmountinglocation.
3.Usingapencil,markthedrillingareainsidethemountinglugoneachsideoftheVCM100unit.
4.Usinga3mmdrillbit,drillaholethroughthepencilmarks.
5.AligntheVCM100mountinglugswiththedrillholes.
6.HoldtheVCM100inplace.
7.Usingasuitablescrewdriver,screwtheself-tappingmountingscrewsthroughthemountinglug
holes,intothedrilledholes.
8.Connectthecables,accordingtotheinstructionsprovidedinthishandbook.
9.Holdthecableclampinplaceoverthecables,approximately50mm(2”)belowthemounted
VCM100unit.
10.Usingapencil,markthedrillingareainsideeachmountingbrackethole.
ENSURETHECABLESDONOTCOVERTHEHOLES.
11.Usinga3mmdrillbit,drillaholethroughthepencilmarks.
12.Holdthecableclampinplace,eachholealignedwiththedrillholes.
13.Usingasuitablescrewdriver,screwtheself-tappingmountingscrewsthroughthebracketholes,
intothedrilledholes.
Installation51
To Next Page
Loading...
