Raymarine CYCLONE - Initial Power On Test; Radar Check and Bearing Alignment

11.1Radarscannerinitialpowerontest
Withallcablescorrectlyandsecurelyconnectedtotheradarscanner,andaccesstoamultifunction
display(powerOFF):
1.EnsuretheradarscannerpowerswitchissettoON.
2.Poweronthemultifunctiondisplay.
TheradarscannershouldenterStandbymode.
3.Ifnecessary,adjustthelightingandcontrastonthemultifunctiondisplay.
11.2Radarcheck
Warning:Radarscannersafety
BeforerotatingtheRadarscanner,ensureallpersonnelareclear.
Warning:Radartransmissionsafety
Theradarscannertransmitselectromagneticenergy.Ensureallpersonnelare
clearofthescannerwhentheradaristransmitting.
Checkingtheradar—RayNetdisplays
TheseinstructionsapplytomultifunctiondisplaysrunningLightHouse™3software.
1.SelectaRadarpage.
The‘Off/NotConnected’messageisdisplayed.
2.Select
Ontopowerupyourradar.
Thisprocesswilltakeapproximately70seconds.
Thescannershouldnowbetransmittingandreceiving.
3.Checkthattheradarscreenisoperatingcorrectly.
66