Raymarine Dragonfly 7 - Applications; View Switcher

6.8 Applications
The applications available on your display are
dependent upon product variant.
Description
Applicable
Products
Chart application — provides a
2D graphical view of your charts
to help you navigate. Waypoint
and track functions enable you to
navigate to a specic location or
record where you've been. Chart
cards provide higher levels of
detail.
• Pro
• M
Sonar application — this
application uses CHIRP processing
to help you target sh beneath your
vessel. You can also view water
depth, water temperature and mark
points of interest such as shing
spots or wrecks.
• DVS
• Pro
DownVision application —
this application gives increased
coverage either side of the vessel in
high denition. CHIRP processing
and higher operating frequency
allows greater depth resolution,
making it easier to identify bottom
structures around which sh may
reside. You can also view water
depth, water temperature and mark
points of interest such as shing
spots or wrecks.
• DV
• DVS
• Pro
Tools & Settings — provides
access to alarms, system settings,
backup and reset features.
• DVS
• Pro
6.9 View switcher
Products that include more than 1 application use
the View Switcher to cycle through available views.
Fullscreen and splitscreen application views are
available.
1 View thumbnails
2 Active application
3 View switcher
4 View switcher titlebar
The views available are dependent on product
variant but can include:
• Chart application
• Sonar application
• DownVision application
• DownVision / Sonar application — splitscreen
• Chart application / Sonar application — splitscreen
• Chart application / DownVision application —
splitscreen
• Tools & Settings
Opening the View switcher
From the top level application state (Motion mode
or Scrolling mode):
1. Press the Back button.
Using the View switcher
To select a view follow the steps below.
With the View switcher displayed:
1. Use the Directional controls to highlight a view.
2. Press the OK button to display the chosen view.
Selecting the active pane in splitscreen
views
When a splitscreen view is displayed you can
change the active pane (the pane that you want to
control) using the View switcher.
With a splitscreen view displayed.
1. If required press the Back button to change the
Chart application to Motion mode, or the Sonar
and DownVision applications to Scrolling mode.
46
Dragony 6 / Dragony 7