4. Bed the mounting ring on a thin coat of silicon sealant.
5. Use three 6 mm (
1
/
4
in) diameter bolts, nuts and washers to attach
the mounting ring to the backing plate (with the backing plate on
the other side of the mounting surface, as shown above).
6. Screw the mounting socket firmly into place.
Note: When the autopilot is not in use, you can unscrew the complete
rod assembly to leave the cockpit unobstructed.
Tiller pins
Your Raymarine dealer can also supply the following lengths of tiller
pin for other non-standard installations.
Description Size Part no.
Small threaded tiller pin 25 mm (1.0 in) D014
Extra length tiller pin 72 mm (2.8 in) D020
Extra length threaded tiller pin 72 mm (2.8 in) D021
81131_8.book Page 59 Thursday, October 7, 2004 11:03 AM
To Next Page
Loading...
