Remote Display
28
www.raymarine.com
To alter the position of a display in the list of controllable displays:
Press the button to scroll down the list. The sequence number of
the display in the list of controllable displays is shown by the cursor.
Press the button, the selected display entry will flash.
Press the button until the required sequence number appears
beside the display.
Press the button to confirm the new sequence number. All displays
below the selected display are pushed down the list.
S33 Reset List
Returns the list of controllable displays to its default settings.
Options Chapter
S34 Auto Networking
Adds display units or transducers to the Micronet network.
This function is only available on the display which was used
to power up the system. Refer to the "Auto Network" sheet for
further information.
S35 Pocket Mode
Sets the time out value for Pocket Mode, the options are OFF,
15, 30, 60 or 120 seconds.
S36 Key Lock
Enables the key locking feature.
See Page 9 for the key locking process.
S37 Time
The number of hours added or subtracted from UTC (GMT)
to allow the display to show local time.
S38 Light
Configures the display to control the system backlighting or
just its own backlighting.
The options are: Network/Local.
To Next Page
Loading...
Need help?
General
