Seatrial and Calibration
31
www.raymarine.com
4 Seatrial and Calibration
Once the Micronet system has been installed on the vessel and Auto
Networking has been completed it is necessary to carry out Calibration.
It is not safe to use the displays for navigational purposes until
Calibration has been carried out correctly.
4.1 Depth Offset
The default depth offset is 0.0 making the display read the depth below
the transducer. By adding a +ve or -ve offset the display will show the
waterline depth or depth below the keel respectively.
To enter a depth offset:
Press and hold the button for 2 seconds to enter Setup.
Press the button repeatedly to scroll to the Sensors chapter.
Press the button to enter the sensors menu.
Press the button repeatedly to scroll to the Depth page.
Press the button to advance to the Keel/Waterline Offset parameter.
Press the button to enter Edit Mode, the parameter
value will flash.
Press the and buttons to change the value.
Press the button to exit Edit Mode.
Press and hold the button to exit Setup and return to normal
operation.