Raymarine ST70 - Setup Procedures

ST70 instrument - organizing your pages
Setting page rollover
You can set a rollover value so that operational pages are automatically displayed in
sequence, one after the other.
Use the procedure on this card to:
• Set a rollover period and activate the automatic rollover.
• Switch off the rollover to return to manual page selection.
Setting rollover
1. Select Main Menu
Press MENU to display the Main Menu then use < or > to
scroll to
Display Settings .
Press ENTER to display the Display Settings menu.
2. Initial actions
At the
Display settings menu, use < or > to scroll to the
Rollover option.
Press
ENTER to show the Rollover setup box.
3. Set rollover value or switch rollover off
If you want the operational pages to cycle round automati-
cally, use < or > to set the rollover to the number of seconds
you want each operational page to be displayed.
Note: If you are using the rollover feature, it is recommended you switch off pages
you do not require (see Card 5).
If you want to stop the rollover and manually select your
operational pages, use < or > to set the rollover to OFF .
Returning to normal operation
Press ENTER to save your setting and return to the Display Settings menu then:
1. Press
CANCEL to select the Main Menu.
2. Press CANCEL to return to your operational page.
D9328-1
Press ENTER to select
Main Menu
Display Settings
D10040-1
i
Press ENTER to select
Display Settings
Rollover
Automatic page rollover
D10039-1
i
i
Press ENTER to accept
Rollover
4
< & > adjust rollover period.
CANCEL exits without saving.
Secs
Card
6
81281_1.book Page 15 Monday, April 30, 2007 3:31 PM