Raymarine ST70 - Changing the Layout of a Page

ST70 instrument - organizing your pages
Changing the layout of a page
Rebuilding pages
If you want to make changes to the way a page is laid out, use the procedure on this card to
rebuild the page with a different layout and different data.
1. Go to Main Menu
Press MENU to display the Main Menu then use < or > to
scroll to
Page layout .
Press ENTER to display the Select page menu.
Shortcuts: From an operational page you can directly access the frame select
box (see step 5 below) for that page, by holding down
ENTER for 1 second.
2. Select the page you want to change
Use < or > or to select the page you want to change.
Press
ENTER to display the Setup options menu for the
selected page.
3. Select Rebuild page
Use
< or > to scroll to Rebuild .
Press ENTER to display the Layout select menu.
4. Select page layout
Use
< or > to highlight the page layout you want. The follow-
ing layouts are available:
When you have selected the layout you want, press
ENTER
to go to the frame select box.
D9640-1
Press ENTER to select.
Main Menu
Page Layout
D9260-1
Press ENTER to select.
Page Layout
Page 1 On
Select the page you wish to
configure.
i
D9340-1
Press ENTER to select
Page 1 Setup
Rebuild
D9341-1
Press ENTER to select.
Page Layout
Layout 1
Select the layout you wish to
use.
i
continued ...
Card
8
81281_1.book Page 23 Monday, April 30, 2007 3:31 PM