ST70 instrument - organizing your pages
Changing the information on a page
5. Select the required data group
Use
<
or
>
to select the data group that contains the data
item that you want (
Depth
shown here).
If you don’t know which group you need, select
ALL
.
Note: ST70 supports a wide range of data. Refer to Card 14 for a full data list.
Press
ENTER
to go to the data select menu.
6. Choose the data you want
Use
<
or
>
to scroll to:
• The data you want
and
• The style in which you want the data displayed. The styles
available depend on the data type, but in many cases,
data is available in the following formats:
• Analog dial.
• Numeric value.
• Graph.
Press
ENTER
to select the data and return to the frame select box.
7. Set up other frames
To set up other frames on this page, repeat the procedure from step 4 to step 6.
8. Complete page setup
When you have completed the setup for the selected page,
ensure the frame select box is displayed, then use
<
,
>
,
and/or as appropriate, to move the highlight to the Save &
Exit icon.
Press
ENTER
to return to your operational page, with the
changes applied.
Press
CANCEL
to return to your operational page without
applying the changes.
D9274-1
Press ENTER to select
Page 1 Frame A
Depth
Select the data items group.
i
D9286-1
Press ENTER to select
Page 1 Frame A
Minimum Depth
Select the new data item for this
frame.
i
D9338-1
i
Press ENTER to select
Page 1
Save and exit.
CANCEL exits without saving.
Save & exit
Xxx
xx
0
.0
Xxx
xx
0
.0
Xxx
xx
0
.0
Xxx
xx
0
.0
Xxx
xx
0
.0
Xxx
xx
0
.0
7
Card continued
81281_1.book Page 22 Monday, April 30, 2007 3:31 PM
To Next Page
Loading...
