D9337-1
Depth
ft
9.
0
Lat
N
Speed
kts
7.
0
Heading
xx
63
Time
24H
11:23
o
47
o
Lon
47
Power Down
3
Switching off an ST70 Instrument
To switch off your ST70 instrument, hold down for
1 second, to display the count-down popup, then continue to
hold down until the display counter reaches zero. At that
point:
• The display goes blank.
• The instrument power down is complete.
Resolving problems
In the unlikely event that you experience problems using your ST70 instrument, refer to the
troubleshooting procedures in the ST70 Instrument User Reference Manual.
If you need further assistance, please visit the Customer Support area of our web site at:
www.raymarine.com
As well as providing a comprehensive Frequently Asked Questions section and servicing
information, our web site gives e-mail access to the Raymarine Technical Support Department
and details of the locations of Raymarine agents, worldwide.
Telephone help line
If you do not have access to the world wide web, please call our help line.
In the USA, call:
• +1 603 881 5200 extension 2444
In the UK, Europe the Middle East or the Far East, call:
• +44 (0) 23 9271 4713 (voice)
• +44 (0) 23 9266 1228 (fax)
Help us to help you
When requesting service, please quote the following product information:
• Equipment type.
• Model number.
• Serial number.
• Software version.
• Hardware version.
You can find out this information by running the
About Display
diagnostic function (described in
the ST70 User Reference Manual).
ST70 instrument - getting started
Switch on/off & introduction
1
Card continued
81281_1.book Page 2 Monday, April 30, 2007 3:31 PM
To Next Page
Loading...
