Chapter 2: Basic Operation
7
3. If you do not want to accept the new course at this time, either
press the disp key or allow the display to timeout (10 seconds), to
return to the pilot page.
4. To accept the new course at a later time, press set crs to re-display
the new heading.
5. Press auto. A confirmation screen is then displayed. This shows
the new heading and the direction the autopilot will steer (PORT or
STARBOARD) to achieve the new heading.
6. Press auto again. The new heading is then applied and the
autopilot assumes the new course.
Dodging Obstacles in Auto Mode
In order to avoid an obstacle when your vessel is under autopilot
control, select a course change in the appropriate direction (for
example, port 30° = press –10 three times).
118ch02.p65 07/01/99, 12:417
To Next Page
Loading...
