12
ST7000 Plus Autopilot Control Unit Owner’s Handbook
2.6 Setting Up Backlighting and Contrast
Backlighting
To set the backlighting level:
1. Press disp for 1 second, from any mode, to enter illumination
adjustment mode and turn the lights on.
1
D4211-1
2. Press the disp key the necessary number of times to cycle to the
required illumination setting. The settings are LAMP 3, LAMP 2,
LAMP 1, LAMP OFF, LAMP 1, LAMP 2, LAMP 3 etc, with LAMP 3
being the brightest setting.
The display times out to normal operation after 10 seconds of keypad
inactivity.
Pressing any other key before the 10 second time-out will select the
mode assigned to that key (for example, auto selects Auto mode,
standby selects Standby mode).
Notes: If other SeaTalk instruments or autopilot control units are
connected to SeaTalk, the illumination can be adjusted from these
units.
Any illumination adjustments are lost when the unit is switched off.
The keys are still lit at a courtesy level when the display lighting is off.
118ch02.p65 07/01/99, 12:4112
To Next Page
Loading...
