Chapter 4: Customising the System
41
2. There are three depth pages and two water temperature pages.
Data is displayed in the units defined by the selected page.
3. If a man overboard (
MOB
) message is received by the autopilot,
the
BTW
and
DTW
pages will display the bearing and distance to
the
MOB
location, so it is good practice to retain these pages for
display.
Software Version Number
To check the Version of software in ST7000 Plus, hold down the
standby key for 4 seconds.
The ST7000 Plus software version number screen and the course
computer software number screen are then displayed alternately.
Course computer
software version
ST7000 Plus
software version
D4374-1
4.2 Dealer Setup: Type 100/300 Course Computer
This section applies if you have installed the ST7000 Plus as the
control unit for a Type 100/300 Course Computer. If you are using the
ST7000 Plus as a repeater for another autopilot system, refer to the
Dealer Setup instructions in the handbook for the main control unit.
Dealer Setup is used to customise the autopilot to your boat. However,
once the Pilot Type is set, the factory defaults will provide safe
performance for initial sea trials, and fine tuning is not normally
required. The flow chart below shows you how to enter Dealer Setup,
scroll through the setup displays, adjust the values and exit.
118ch04.p65 07/01/99, 12:4241
To Next Page
Loading...
