Raymarine ST70+ - Chapter 3:Setup Information; Introduction; General Setup; Changing Language

47
Chapter 3: Setup Information
3.1 Introduction
This chapter describes the setup functions not used on a day-to-day basis but which
may be needed from time to time, to optimize the performance of ST70+.
3.2 General setup
Many operating parameters are set during commissioning and should not need to be
changed again. However, if parameters are not as you want, you can change:
• The language. See below.
• The vessel type. See below.
• The time/date format. See below.
• The local time. See below.
• The method of ground wind calculation. Refer to Chapter 2: Commissioning Pro-
cedures.
• The magnetic variation. Refer to Chapter 2: Commissioning Procedures.
• The response rate of an instrument. Refer to Chapter 2: Commissioning Proce-
dures.
• The display page layout and content. Refer to the ST70+ Operating Guide.
Other setup procedures likely to be useful on a day-to-day basis are described in your
ST70+ Operating Guide, so not repeated here. These procedures include:
• Setting local time
• Setting data units
• Change screen colors
• Setting timers
• Setup Pilot View Data Boxes
• Switching Instrument pages on & off
• Setting Instrument page rollover
• Changing the information on an Instrument page
• Changing an Instrument page layout
• Using timers
• Setting alarms
Changing language
Any change to the language is applied across the entire ST70+ system.
To change the language used on your ST70+system:
1. At a convenient ST70+ keypad use the Select Display button to select a conve-
nient display, then press MENU to display the Main menu.
2. Scroll to Advanced options then press OK to display the Advanced options menu.
3. Scroll to select the
Language option, then press OK to display the Language menu.
4. Scroll to select the language you want.
85024_1.book Page 47 Tuesday, January 27, 2009 11:31 AM