WR14 / WR50-12/13 Winding Resistance Meter Instruction Manual
When remote control is chosen for a device, a new ribbon tab is created and automatically selected.
Running processes like remote control or data exchange will not be affected. The newly created ribbon
tab may appear differently for several Raytech devices.
The device control section contains all options to set up a device and do measurements. With a few
clicks, a measurement is started and the results are displayed in the results section immediately.
Details about the device status and communication are shown in the status section. In the screen
example below, a winding resistance meter is connected. The meter status is safe and data exchange is
listed in the console.
USB DRIVER FOR T-BASE PRO
The USB Drivers must be activated to allow communication between the Raytech instrument and a
computer. This is accomplished by entering a simple Service Code: 2001#
This is described further in āRaytech USB Driver for T-Baseā on page 100.
To Next Page
Loading...
