WR14 / WR50-12/13 Winding Resistance Meter Instruction Manual
WARRANTY CONDITIONS
Raytech USA, Inc. warrants to the original purchaser that its products shall be free from defects in
material and workmanship under normal use and service for a period of 60 months from the original
date of shipment. An additional extended warranty period is provided, at cost to the end user, for the
products covered under this warranty if the products are returned on each calendar year from the
original date of shipment, prepaid, to Raytech USA, for system evaluation.
The obligation of Raytech USA, Inc. under this warranty is limited, in its exclusive option, to repair,
replace, or issue credit for parts or materials which prove to be defective, and is subject to purchaser’s
compliance with the Raytech USA, Inc. warranty claim procedure as set forth within this manual.
Raytech USA, Inc. shall at their option and expense, repair or replace any part or parts that prove to be
defective within the warranty limitation period irrespective of the operating time of the test equipment,
provided that the cause of the defect occurred prior to the time at which the risk was passed. The
purchaser is obligated to immediately notify Raytech USA, Inc. in writing of any defects of the supplied
test equipment. Raytech USA, Inc. must always be given the opportunity to rectify a defect within a
reasonable amount of time. The purchaser shall grant adequate amount of time that the test equipment
shall be repaired.
This warranty covers only those parts and/or materials deemed to be defective resulting from
manufacturer’s workmanship. The liability of Raytech USA, Inc. shall be limited to the repair,
replacement, or issuance of credit for parts deemed defective within the meaning of this warranty. Costs
for all transportation, labor or other expenses that may have occurred incidental to the inspection,
repair, replacement, or issuance of credit for such parts and/or materials shall be the sole responsibility
of purchaser. This warranty shall not apply to any accessories, parts, or materials not manufactured or
supplied by Raytech USA, Inc.
Equipment must be returned, prepaid, with a Return Material Authorization (RMA) to:
Raytech USA, Inc.
118 S. 2nd Street
Perkasie, PA 18944 USA
Tel. + 267 404 2676
Fax. + 267 404 2685
www.RaytechUSA.com
To Next Page
Loading...
