Installation
MI 17
Figure6:ConnectingofCablestotheElectronicBox
5. Putthefollowingonthecable(asshowninthefigure
above):
the cap (1), the plastic compression fitting (2), the rubber
washer(3)andoneofthemetalwashers(4).
6. Spread the cable shield (5) and then slip the second metal
washer(4)onthecable.Notethattheshieldmustmakegood
contacttobothmetalwashers.
7. Slip
the wires (6) into the electronic box far enough to
connecttothepowerandoutputterminals.
8. Screw the cap (1) into the electronics box. Tighten snuggly.
Donotovertighten.
9. Connectthewires(6)tothepowerandoutputterminalson
theprintedcircuitboard.
Cable that has to be
installed b
To Next Page
Loading...
