Operation
34 MI
6Operation
Once you have the sensor positioned and connected properly, the
systemisreadyforcontinuousoperation.
The operation of the sen sor can be done by means of the built‐in
control panel on the sensor’s electronic board or by means of the
softwarethatcamewithyoursensoroptionally.
6.1ControlPanel
Thesensoriseq uippedwithacontrolpanelinthesensor’selectronic
housing, whichhassetting/controllingbuttonsandanLCD display.
The actual function mode is shown on the display with a speci fic
modesymbol.
Figure24:ControlPanel
Output Jumper
Mode Symbol
Value
Mode Button
Value Buttons
To Next Page
Loading...