RayTek MI Miniature Infrared Sensor - Signal Output

Installation
MI 19
5.3.1SignalOutput
Figure8:WiringoftheSignalOutput(mAorV)
The signal output can be configured either as current or as voltage
output.
The minimum load impedance for the 0 to 5 V output must be
100kΩ.
Themaximumcurrentloopimpedanceforthe0/4to20mA
output
can be 500Ω, and the power supply and loop impedance must be
matchedasshownbelow.

Figure9:Max.LoopImpedancedependingonPowerSupply
Power + Power –
Signal
Ground
Signal
Out
p
ut
Max. Loop Impedance [Ω]
Power
Supply
[V]
Max. Loop Impedance