ProgrammingGuide
MI 69
After switching the power to “ON“, the device is sending a
notification:
#XICRLF “#“istheparameterfor“Notification“
“XI“ is the value for the notification (here “XI“; unit
switchesto“ON”)
“CR““LF“(0Dh0Ah)isclosingtheanswer.
Errormessage
*SyntaxError“*“isthecharacterfor“Error“
11.3DeviceInformation
Thisinformationisfactoryinstalled,readonly.
Command Description Answer
(Example)
?XU Device name “XUMILT“
?DS Remark (e.g., for specials) “!DSRAY“
?XV Serial Number “!XV0A0027“
?XR Firmware Revision Number “!XR2.08“
?XH Maximum Temp. Range: e.g. for LT head “!XH0600.0“
?XB Minimum Temp. Range: e.g. for LT head “!XB-040.0“
Table1:DeviceInformation
To Next Page
Loading...