ProgrammingGuide
68 MI
11.2GeneralCommandStructure
Requestinga parameter(PollMode)
?ECR “?“isthecommandfor“Request“
“E“istheparameterrequested
“CR“(carriagereturn,0Dh)isclosingtherequest.
Remark: It is possible to close with “CR“ “LF“, 0Dh,
0Ah,butnotnecessary.
Settinga parameter(PollMode)
Theparameterwillbestored
intothedeviceEEPROM.
E=0.975CR “E“istheparametertobeset
“=“isthecommandfor“setaparameter“
“0.975“isthevaluefortheparameter
“CR“(carriagereturn,0Dh)isclosingtherequest
Remark: It is possible to close with “CR“ “LF“, 0Dh,
0Ah,butnotnecessary.
Settinga parameterwithoutwritingintotheEEPROM(PollMod e)
Thisfunctionisfortestpurposes only.
E#0.975CR “E“istheparametertobeset
“#“isthecommandfor“setparameterwithoutwriting
intotheEEPROM“
“0.975“isthevaluefortheparameter
“CR“(carriagereturn,0Dh)is
closingtherequest.
Remark: It is possible to close with “CR“ “LF“, 0Dh,
0Ah,butnotnecessary.
Deviceresponseformat:
!E0.975CRLF “!“istheparameterfor“Answer“
“E“istheparameter
“0.975“isthevaluefortheparameter
“CR“„LF“(0Dh0Ah)isclosingtheanswer.
To Next Page
Loading...