RayTek MI Miniature Infrared Sensor

To Next Page

To Previous Page

Accessories

MI 51



Figure34:MountingtheAirPurgeJacket

1. Remove the sensor (1) andcable from the electronic box by

disconnectingthewiresfromtheelectronicbox.

2. OpentheAirPurgingJacket(3,4)

andscrewthewhiteplastic

fitting(2)

ontothesensoruptotheendofthethreads,donot

overtighten!

3. Slipthecable(6)

throughthebackside(4) ofthejacket.

4. ClosetheAirPurgingJacket(3,4)

andreconnectthewiresto

theelectronicboxandapplythemountingnut(5).

RayTek MI Miniature Infrared Sensor - Page 59