Attaching / Removing the Antenna
1. With the radio turned off, set the antenna
in its receptacle and turn clockwise until it
is tight. (See Figure 2)
2. To remove the antenna, turn the radio off
and turn the antenna counterclockwise.
Figure 2
Attaching / Removing the Belt Clip
Using a small screwdriver, align the belt clip’s
screw holes to the radio’s chassis. Attach by
turning the screws clockwise into the belt clip’s
screw holes. Remove by doing the reverse.
(See Figure 3)
Figure 3
* If antenna needs to be
replaced, use only RCA
Communications Systems
antennas. Incorrect or
damaged antennas may
reduce radio coverage
To Next Page
Loading...
Need help?
General
