To Next PageTo Next Page
Need help?Do you have a question about the RCm BYTE II Series and is the answer not in the manual?
Provides data for identifying the machine model and specifications.
Steps to attach the squeegee assembly to the machine's tow plate.
How to adjust the squeegee's tilt for proper water collection and drying.
Describes operation for light and heavy dirt, and the GO GREEN energy-saving mode.
Procedures for safely stopping brush rotation, suction, water flow, and finishing work.
How to clean the brush, check wear, and replace it if necessary.
Procedure for cleaning the squeegee and its blades to ensure optimal drying performance.
Steps to empty and clean the dirty water tank and its filter component.
Instructions for cleaning the clean water tank and filter, with precautions against sediment.
Step-by-step guide on how to remove and install brush assemblies, both manually and automatically.
Specific steps to remove, turn, and replace the front squeegee rubber.
Specific steps to remove, turn, and replace the rear squeegee rubber.
Lists alarms originating from the machine's function control board and their respective solutions.
Lists alarms related to the traction control board and provides troubleshooting steps.
Covers general system alarms not specific to function or traction boards, with troubleshooting advice.
Guides on adjusting specific settings like language, battery type, delays, and display contrast.
Instructions on how to safely exit the parameter adjustment mode.
Precautions for using cleaning agents and protective measures during machine cleaning operations.
Warning against using the machine in environments with explosive gases, powder, or vapors.
Guidelines for the proper disposal of collected materials, including used batteries, according to environmental laws.
General
