RCm Mega I Series - User Manual

Questions and Answers

R
Raymond ShawAug 12, 2025
Why doesn't the RCm Scrubber squeegee dry perfectly?
- F
  Frederick MartinezAug 12, 2025
  If the squeegee on your RCm Scrubber isn't drying properly, several factors could be the cause. The squeegee rubbers may be worn and need replacement, or the squeegee itself might be dirty and require cleaning. A foreign object may be lodged in the squeegee, or the vacuum pipe could be detached or clogged, needing reattachment or cleaning. Additionally, check if filter 12 and cup 13 are dirty and clean them if necessary. Ensure the squeegee is correctly adjusted and the water drain tap is closed. In more serious cases, the vacuum motor might be burnt out or the carbon brushes worn, requiring replacement.
A
andradedarleneAug 18, 2025
How to improve cleaning performance of my RCm Scrubber?
- K
  Karina JohnsonAug 19, 2025
  If your RCm Scrubber isn't cleaning effectively, consider these points: the brushes might be too worn and need replacing. The detergent you're using might not be suitable, so try a different one. The brushes might not be appropriate for your floor type; switch to a more suitable type. Finally, you might be moving too fast; try slowing down.
K
Kathleen CarrollAug 27, 2025
What to do if detergent solution isn't reaching the brushes on my RCm Scrubber?
- J
  James SmithAug 27, 2025
  If the detergent solution isn't reaching the brushes on your RCm Scrubber, or only a small amount is, here are some things to check: the pipelines supplying water to the brushes may be clogged and need cleaning. Ensure the solution tap is opening correctly. Inspect the feeding pipe for any squashing; restore or replace it if necessary. Make sure the solution tank has water. Also, the solution filter might be dirty and need cleaning. If these steps don't work, the electrovalve or the pump (if equipped) may be faulty and require replacement or repair.
C
Caleb PetersonSep 3, 2025
Why won't my RCm Scrubber start?
- J
  Jonathon HallSep 4, 2025
  If your RCm Scrubber isn't starting, try these steps: ensure the main key switch is inserted and turned to position 1. Check the batteries to see if they are flat and recharge them if necessary. Make sure the batteries are properly connected. Also, examine the fuses (F4 - Fig.10) for the dashboard and other fuses, and refer to NOTE ( ! ). Finally, check if the emergency stop button is engaged and, if so, release it and repeat the start-up procedure (see USING THE SCRUBBER/ DRIER. - fi g.3)