To Next PageTo Next Page
Need help?Do you have a question about the RealCup RC400 and is the answer not in the manual?
Provides critical safety alerts and definitions for potential hazards like electrocution, burns, and injuries.
Guidelines for selecting a proper location for the brewer, ensuring stability and safety.
Details the water inlet and power connection points for the brewer.
Specifies the required water pressure and recommends an external water filter.
Outlines the requirements for a dedicated 120V, 15A electrical circuit and proper plug connection.
Step-by-step procedure to prime the brewer's internal hot water tank before operation.
Allows modification of the access passcode for advanced settings.
Enables changes to the available beverage types displayed on the brewer.
Allows adjustment of the available beverage dispensing sizes.
Enables adjustment of the water temperature used for brewing.
Provides information on tracking the number of brew cycles.
Displays a list of potential error messages and links for troubleshooting.
Allows modification of service contact information displayed on the brewer.
Enables fine-tuning of dispensed liquid volumes for beverages.
Detailed steps for changing the brewer's access passcode.
Guide to selecting and deselecting beverage types for display and use.
Procedure for modifying available beverage sizes and setting a default.
Instructions on how to increase or decrease the water temperature setting.
Details on how to reset or view brew counts.
Process for editing service contact name and phone number via character screens.
Procedure to reset all brewer settings to their original factory defaults.
Explains the meaning of different colors displayed by the brew button.
Allows adjustment of dispensed brew volumes by a percentage from the factory default.
Step-by-step guide for replacing worn or damaged probe seals in the brew chamber.
Instructions for removing and replacing the brewer's drip tray assembly.
Procedure for replacing the flip-down grid sub-assembly using a screwdriver.
Steps for accessing and replacing components within the brewer's reservoir.
Overview for gaining access to the brewer's internal components for servicing.
Detailed steps for replacing the check valve and the 3-way valve.
Instructions for servicing or replacing the air pump and relief valve.
Procedures for servicing or replacing the flow meter and water pump.
Steps for replacing the brewer's bezel and capsule holder.
Guide for servicing the probe holder assembly, including tube and screw removal.
Instructions for servicing the linear damper and interlock switch assembly.
Steps to access and remove the electronics module and its components.
Procedures for accessing and servicing water inlet valve, USB board, and power cord.
Instructions for servicing the Triac assembly and the transformer.
Steps for accessing and servicing the brewer's tank assembly.
Guidelines for cleaning external parts, drip tray, and reservoir, avoiding harsh chemicals.
Procedure to clear water from the brewer, including steps for Auto-Fill models.
Instructions for descaling the brewer using vinegar solution to remove mineral buildup.
General