3. Scanning Mode Setting
Three kinds of scanning modes are supported.
3.1. Manual Trigger mode (default) :
Press the trigger, the scanner will emit light and read the barcode. Release the
trigger, the scanner will stop reading barcode and the light will go off.
** Scan the following codes to set the scanner to Manual trigger mode .
Manual trigger mode (default)
3.2. Continuous Scanning Mode
There’s no need to click the trigger in this mode. The red light of the scanner
will be on at a certain frequency.
The red scanning light will go off once the scanner scans barcode successfully
and the scanner will enter into next scanning automatically after a intermittent
time . And the red scanning light of the scanner will be on again once the
waiting time passes
** Scan the following codes to set the scanner to Continuous Scanning Mode.
Continuous Scanning Mode
To Next Page
Loading...
