REALINN RL6100-2D - Page 45

41
Third step : Scan one of the following setup code to choose the data
group.
Note 1： if you do not choose the data group, the scanner will take “Data
group 1” as default setting.
Note 2
The data group is used to distinguish between different setting events.
it work on the following circumstances:
1).Differentiating the setting for different barcode types
2).Distinguish add / delete prefix or suffix
Different events can take effect at the same time.
Example 1 :
If you want to put “A” before the Code39 type barcode, put "B" before the
Code128 type barcode .
The setting steps is ：
Insert charater> Code39>Data group 1>Before barcode>065 A>Saving
settings
Data group 1*
Data group 2
Data group 3
Data group 4
Data group 5
Data group 6
Data group 7
Data group 8