Realistic PRO-50 - Searching for and Temporarily Storing Active Frequencies; Listening to the Monitor Memory

5. If you want the scanner to pause for 2 seconds after each
transmission before it proceeds to the next channel,
press */DLY until D appears on the display. See “Delay.”
6. Repeat Steps 1-5 to program more channels. Or, if you
want to program the next channel in sequence, repeat
Steps 2-5.
SEARCHING FOR AND TEMPORARILY
STORING ACTIVE FREQUENCIES
If you do not have a reference to frequencies in your area,
search to find a transmission. See also “Guide to the Action
Bands” in this manual.
1. Press MANUAL or PGM. Enter the frequency from which
you want to start your search.
Or press MANUAL, a channel number, and MANUAL or
PGM to select the channel from which you want to start
your search.
2. Press A or ▼ to search up or down from the displayed
frequency.
3. When the scanner stops on a transmission, press O/MON
to store the frequency in the monitor memory, or press A
or T to continue the search.
Note: Press */DLY to make the scanner pause 2 seconds af¬
ter a transmission before it proceeds to the next frequency.
LISTENING TO THE MONITOR
MEMORY
You can listen to the monitor memory by pressing MANUAL
and then O/MON.