RTL87x2x Quick Start User Guide
Copyright 2023 Realtek Semiconductor Corporation.
All Rights Reserved. I
COPYRIGHT
©2023 Realtek Semiconductor Corp. All rights reserved. No part of this document may be reproduced, transmitted,
transcribed, stored in a retrieval system, or translated into any language in any form or by any means without the
written permission of Realtek Semiconductor Corp.
DISCLAIMER
Realtek provides this document ‘as is’, without warranty of any kind. Realtek may make improvements and/or
changes in this document or in the product described in this document at any time. This document could include
technical inaccuracies or typographical errors.
TRADEMARKS
Realtek is a trademark of Realtek Semiconductor Corporation. Other names mentioned in this document are
trademarks/registered trademarks of their respective owners.
USING THIS DOCUMENT
This document is intended for the software engineer’s reference and provides detailed programming information.
Though every effort has been made to ensure that this document is current and accurate, more information may have
become available subsequent to the production of this guide.
ELECTROSTATIC DISCHARGE (ESD) WARNING
This product can be damaged by Electrostatic Discharge (ESD). When handling, care must be taken. Damage due
to inappropriate handling is not covered by warranty.
Do not open the protective conductive packaging until you have read the following, and are at an approved anti-
static workstation.
Use an approved anti-static mat to cover your work surface
Use a conductive wrist strap attached to a good earth ground
Always discharge yourself by touching a grounded bare metal surface or approved anti-static mat before
picking up an ESD-sensitive electronic component
If working on a prototyping board, use a soldering iron or station that is marked as ESD-safe
Always disconnect the microcontroller from the prototyping board when it is being worked on
To Next Page
Loading...
