Reboot RBM1600 - User Manual

Version Number: RBM1600-20201221A1
1
Operation Manual
Reboot RBM1600 welding machines adopts the latest pulse width modulation (PWM) technology and
insulated gate bipolar transistor (IGBT) power module, which can change work frequency to medium frequency so as
to replace the traditional Transistor transformer with the medium frequency transformer. its characterized with
portable, small size, light weight, low consumption and etc. It is also an intelligent and easy-to-operate multi-function
welding machine with MMA, MIG GAS, MIG GASLESS and LIFT TIG. It has the characteristics of strong welding
performance and diversified usage scenarios. It can be used in both gas and gasless conditions, and the welding
effect is excellent. It is highly praised by welding enthusiasts. It is also very friendly to beginners in welding and can
quickly get started.
Part 1: Machine Introduction
1. Current display meter
The digital Ammeter is used to display the actual output current of the power source.
It is also used to display Parameters in Programming Mode.
Depending on the Programming Parameter selected, the status indictor adjacent to the Ammeter will illuminate to show the units
of the programming parameter.
When welding, the Ammeter will display actual welding current.
2. Voltage display meter
3. Choose the wire diameter and the choice of gas welding and gasless welding
4. MIG/MMA/LIFT TIG Function selection
5. Small range voltage adjustment and inductance adjustment
It is recommended that the voltage does not need to be adjusted. The machine is a unified machine. The voltage, current and
wire feeding speed are automatically matched. Only when the deviation is too large, it can be adjusted appropriately. Inductance
adjustment: If the splash is too large or the welding pool is not deep enough, it can be adjusted to a larger value, otherwise it can
be smaller.
6. Adjust the value knob

Reboot RBM1600 Specifications

General

Frequency	50/60Hz
Duty Cycle	60%
Efficiency	85%
Insulation Class	F
Protection Class	IP21S
Welding Type	MMA (Manual Metal Arc)
Input Voltage	220V
Output Current	160A