14
HIGH ACTING WITH TIMEOUT LOW ACTING WITH TIMEOUT
HIGH ACTING WITH NO DELAY HIGH ACTING WITH DELAY
6.5 MODULE 9 - Factory Service Operations (
;345$
)
PARAMETER MENU
RESTORE FACTORY DEFAULTS
Use the arrow keys to display 5*+& >> and press PAR.
The meter will display
!&$&% and then returns to 5*+& <0.
Press DSP key to return to the Display Mode. This will
overwrite all user settings with the factory settings.
Pressing the PAR and DSP keys at the same time on power-up will load the
factory settings and display
&!!9. This allows operation in the event of a
memory failure or corrupted data. Immediately press the RST key and
reprogram the meter. If the meter is powered down again before pressing the
RST key, the existing dynamic data will not be overwritten.
!
"
>>
5*+&
To Next Page
Loading...
