Red Seal Measurement Neptune RML2000 - Printer and RTD Configuration Settings

37
7. Select the required display resolution for the volume units. [Enter]
VOLUME
RESOLUTION
0.001
0.01 0.1
8. Select the type of input pulses to be counted. [Enter]
NOTE: For a mechanical positive displacement meter, set PULSE TYPE to QUAD. For a mass ow
meter, set to SINGLE.
PULSE TYPE
SINGLE
DUAL QUAD
9. Set PRINTER STATUS CHECK to ON.
PRINTER
OFF
STATUS CHECK
ON
10. Set RTD ACTIVE to NO.
RTD ACTIVE?
NO YES