34
5. START UP AND CALIBRATION
This procedure applies to E4000 rmware version EA.01.08E and later. The rmware version of the E4000 can be
determined by viewing the display during the rst 5 seconds after powering up the register (the version will be shown
in the lower left corner of the display), or by printing a calibration report. To calibrate E4000s with earlier rmware
versions, contact the factory.
5.1 E4000 Command Menu Overview
The E4000 will turn on automatically on power up. This is indicated by the LCD display illuminating, fol-
lowed by a screen test operation and a display of the software version. The screen will stop at the root
software menu in the following condition:
ROUTE SUPERVISOR W&M
5.1.1 Route Mode
The Route Mode is the menu selection the operator uses to make deliveries from the meter, print out
reports that record what deliveries were made and how the register is calibrated, and access the volume
of product on the truck.
DELIVERY VOL REPORTS
Register functions carried out in Route Mode are as follows:
• Select 1 of 10 possible programmed products. priced or unpriced
• Display delivered volume and print delivery ticket or priced invoice
• Make deliveries
• Print End-of-Shift Report to record number of deliveries made and total volume of
each product delivered.
• Report current cumulative totalizer value
• Print Calibration Report to show the K-Factors and temperature compensation parameters set for each
programmed product
• Enter, edit, and access the onboard volume
5.1.2 Supervisor Mode
The Supervisor Mode is the menu selection that allows an operations supervisor to set up password
protected parameters within the E4000 that dictate how the register is operated.
SUPERVISOR
PRODUCT DATA
To Next Page
Loading...