Red Seal Measurement Neptune RML2000 - Printing a Calibration Report; Procedure for Printing Calibration Reports

50
5.5 Printing a Calibration Report
Note: Insert 4 ½”x 11” paper into the printer
1. From the NEPTUNE root menu, press either of the white buttons > or ^, on the four button front panel,
until “ROUTE” is ashing, then press the green START/ENTER button.
ROUTE SUPERVISOR W&M
2. Press > or ^ until “REPORTS” is ashing, then press the START/ENTER button.
DELIVERY VOL REPORTS
3. Press or until “CALIBRATION” is ashing, then press the START/ENTER button.
SHIFT CALIBRATION
4. Press the START/ENTER button when the display reads “PRINT-END-OF SHIFT REPORT?”
PRINT CALIB REPORT
REPORT?
5. Press [Cancel] three times to return to the root menu.
CONSULT YOUR LOCAL WEIGHTS AND MEASURES REPRESENTATIVE FOR GUIDELINES ON
SEALING THIS UNIT.