Page 26 of 28
6.0 Congratulations!
As with any process there is a bit of a learning curve, and the ProtoCycler is a complex system to learn
inside and out. Making it to the end of this instructions manual and learning all of its ins and outs
hopefully means we are well underway to producing your very own filament. So, congratulations on
your new ProtoCycler and taking the first steps towards accomplishing your recycling and filament
creation goals!
If there is anything we can help with please contact our technical support channel via the following
email: techsupport@redetec.com
All the best and happy extruding,
Team ReDeTec
To Next Page
Loading...
