EasyManua.ls Logo

Redliro JK1608E-2 - Assembly and Folding; Assembly Steps

Redliro JK1608E-2
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
service@redliro.com service@redliro.com
14
15
Start/Stop button:
Press Start/Stop button in standby mode and the treadmill will start after 3 seconds. The default speed is 0.5
mph.
Press Start/Stop button in preset/custom mode and the treadmill will start immediately, running at preset
values. It will immediately begin accumulating data.
Press Stop button while running belt is in motion and the treadmill will slow down slowly and return to pause
mode.
In the pause mode, press Start button and the running belt will begin moving at the previous selected
program.
+/- button:
Used for speed adjustment while your device is in use. Speed will be adjusted 0.1 mph each time you press.
Hold for more than 0.5 seconds and the speed will continue to increase or decrease. Can also be used to
adjust settings in preset/custom mode.
M button:
Press the M button while in standby mode to switch to custom mode. Select between time setting (setting
range 5:00 ~ 99:00), distance setting (setting range1 ~ 99miles ) and calorie setting( setting range 20 ~ 990 ).
Press M button to change the cyclic display or xed display mode when in use.
Mute button:
Press the "Mute" button once to mute noise. Press it twice to cancel the operation.
Reset button:
In the pause mode, press Reset button and the running belt will slowly return to standby mode
P button:
In standby mode, the P button is used to select 12 preset automatic programs (P01 ~ P12)
FUNCTION OF THE REMOTE CONTROL
Step 1:
Push back to remove the cover and install the battery.
BATTERY REPLACEMENT
Step 2:
Remove button cell of remote control:
After long-term use, the remote control will have reduced sensitivity or become inoperable due to insu󰀩cient
power, and the battery needs to be replaced. Remove battery cover and take dead batteries out of your
remote control.
Step 3:
Install button cell of remote control:
Ensure you have purchased new batteries that are the right type for the remote control by comparing with the
dead ones. Insert your new batteries into the remote and replace cover. Dispose of old batteries responsibly.
1
1
2
2
3
3
1
2
3

Related product manuals