Reed Instruments R3000SD - Setting the Data Logging Sampling Rate (SP-T); Enabling;Disabling Auto Power off (Poff); Enabling;Disabling the Beeper (Beep)

12
Setting the Data Logging Sampling Rate (SP-t)

 
only) up to 8 hours, 59 minutes and 59 seconds.
2. Press the
and buttons to adjust the required sampling rate by
hours, minutes or seconds as indicated by (h/m/s).
3. Press the ENTER button to conrm each selection.
4. Press the SET button to save the selected sampling rate and jump to

Note: At any time, you can press the ESC
and resume normal operation.
Enabling/Disabling Auto Power Off (PoFF)

1. Press the and buttons to select between ON (enabled) or OFF
(disabled). With the Auto Power OFF feature enabled, the meter will
automatically switch OFF after 10 minutes of inactivity to preserve
battery life.
2. Press the ENTER button to conrm selection.
3. Press the SET
Note: At any time, you can press the ESC
and resume normal operation.
Enabling/Disabling the Beeper (bEEP)

1. Press the and buttons to select between ON (enabled) or
OFF (disabled).
2. Press the ENTER button to conrm selection.
3. Press the SET
Note: At any time, you can press the ESC
and resume normal operation.
continued...
REED Instruments
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com