15
between 1 and 99).
5. Press the and buttons to select one of the 99 data memory
positions in which to record.
6. Press the LOG button again to save a reading to memory.
REC button
2 seconds to resume normal operation.
Automatic Data Logging Mode
In automatic mode the desired data logging sampling rate can be set
between 1 second to 8 hours, 59 minutes and 59 seconds prior to
recording. In order to setup the meter for automatic data logging, follow
steps 1 through 5 below.
1. Press the REC
2. Press the LOG button to enter automatic data logging function as
time a reading is stored.
4. To pause the data logging session press the LOG button and
LOG
button again.
5. To end the current data logging session, press and hold the REC
button for 2 seconds.
Transferring Data from the SD Memory Card to a Computer
1. While the meter is powered Off remove the SD memory card from the
SD card slot.
2. Insert the SD memory card into the computer.
Position Date Time Ch1_Value Ch2_Value
1 19-07-10 11:00:39 3.45 pH 25 Degree_C
2 19-07-10 11:00:43 3.45 pH 25 Degree_C
3 19-07-10 11:00:47 3.52 pH 25 Degree_C
4 19-07-10 11:00:51 3.48 pH 25 Degree_C
5 19-07-10 11:00:55 3.5 pH 25 Degree_C
6 19-07-10 11:00:59 3.46 pH 25 Degree_C
7 19-07-10 11:01:03 3.45 pH 25 Degree_C
8 19-07-10 11:01:07 3.56 pH 25 Degree_C
9 19-07-10 11:01:11 3.45 pH 25 Degree_C
10 19-07-10 11:01:15 3.45 pH 25 Degree_C
11 19-07-10 11:01:19 3.45 pH 25 Degree_C
12 19-07-10 11:01:23 14 pH 30 Degree_C
continued...
REED Instruments
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com
To Next Page
Loading...
