Reed Instruments R3000SD - System Reset; Battery Replacement; Applications

19
System Reset
If the meter becomes unresponsive or if the display freezes, the Reset pin
can be used to reset the instrument.
 
2. After pressing the Reset pin, power the meter back up by holding the
POWER button for 2 seconds.
3. If resetting the meter does not resolve the issue, please return the
meter to the nearest authorized REED distributor or authorized
Service Center for repair.
Battery Replacement
When the low battery icon appears on the LCD, the batteries must
be replaced.
1. Remove the two (2) Phillips screws on the back of the meter directly
located above the top of the kickstand.
2. Remove the battery cover.
 
4. Secure the battery cover with the two (2) Phillips screws.
Applications
 
 
 
 
 
REED Instruments
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com