16
4. To exit manual data logging mode, press and hold the LOG button
for 2 seconds to resume normal operation.
SPL Automatic Data Logging Mode
In automatic mode, the desired data logging sampling rate is set to 1, 2,
5, 10, 30, 60, 120, 300, 600, 1800 or 3600 seconds prior to recording.
In order to setup the meter for automatic data logging, follow steps 1
through 5 below.
1. Press and hold the LOG button to enter automatic data
logging mode.
2. The "LOGGER" will ash every time a reading is stored at the user
selected sampling rate.
3. To pause the data logging session press the LOG button and
LOGGER will stop ashing.
4. To resume press the LOG button again.
5. To end the current data logging session, press and hold the LOG
button for 2 seconds to resume normal operation.
Setup Mode
1. Press and hold the FUNC. button for 2 seconds to enter
Setup Mode.
2. Press the FUNC. button continuously to scroll through the
following parameters.
Parameter Description
dAtE Set the time and date
SP-t Set the data logging sampling rate
PoFF Enable or disable the auto-power off
SEt LC Set Criterion level in dB
SEt LT Set Threshold in dB
SEt ER Set Exchange rate in dB
SPC Check Memory space
CLrE Clear Stored Data
continued...
www. .com
information@itm.com1.800.561.8187
To Next Page
Loading...
