Controller
14 — English Master/Slave Operation — 24.09.2015
C
OK
5. Use the scroll bar to navigate to the "Master/Slave" function.
6. Press "Master/Slave".
– The controller switches to the selected area.
Settings > Service
Master/ Slave >
Master controller >
SD card >
2.9 bar 0 %
Note!
You are within the Master/Slave menu. Adjust the factory settings of the parameters to the device-specific conditions.
8. Press "Address“.
– The controller switches to the address administration.
Settings>Service>Master/Slave
(240) Address 1
(241) Master/Slave No
(242) Number of Slaves 0
(243) Max. pressure deviation 1 bar
2.9 bar 0 %
7. Use the "▲" and "▼" keys to enter the code for accessing
the Master/Slave menu.
– Code: ▼▼▼▲▲
– The controller opens the Master/Slave menu.
Master/ Slave >
Code input
Please enter
the code for
the Master/Slave
2.9 bar 0 %
To Next Page
Loading...
