Controller
Master/Slave Operation — 24.09.2015 English — 19
21. Select the desired function:
• "No"
– Select this function for the master.
– The "29 Communication fault" message is output to
the floating contact.
• "Yes"
– Select this function for the slaves.
– The "29 Communication fault" message is not
output to the floating contact.
• Press "OK" to confirm.
The function for the respective device is selected.
Settings>Service>Master/Slave
(246) Block message 29 PFK?
No
Yes
2.9 bar 0 %
Note!
You have completed the settings in the controllers when all parameters for the master and the slaves are entered.
– Ensure that all devices are set to Master/Slave operation.
OK
To Next Page
Loading...
