Chapter 3
Safety Lanyard (Interrupter Switch)
e safety lanyard (used on selected control levers) sometimes called
an interrupter switch is attached to the operator and the remote
control panel. Should the operator lose control of the vessel and
become dislodged from his/her seat or fall overboard, the lanyard
will shut the engine o .
Make sure the lanyard is fastened to a clothing part such as a belt
before operating the vessel. Flip the switch to the run position before
starting the engine.
3-36
ATTACH TO OPERATOR
IF THE INTERRUPTER SWITCH IS IN THE “OFF” POSITION,
THE ENGINE WILL CRANK OVER BUT WILL NOT START.
ENSURE THE SAFETY LANYARD IS ATTACHED CORRECTLY
AND SWITCHED TO THE “RUN” POSITION.
INTERRUPTER SWITCH MUST BE ATTACHED TO THE OPERATOR
WHILE THE ENGINE IS RUNNING. A QUALIFIED OPERATOR
MUST BE IN CONTROL AT ALL TIMES.
READ THE OWNER’S MANUAL BEFORE USE.
To Next Page
Loading...
