Chapter 6
6-22
POWERTOWER (Continued)
AVOID BODILY INJURY!
WHEN OPERATING POWERTOWER
KEEP ALL BODY PARTS CLEAR
OF TOWER HINGE MECHANISMS.
Make sure the operator and all aboard read and understand the
above warning.
Before energizing the PowerTower switch explain to all passengers
that they shall maintain a safe distance from the tower hinge
mechanisms located at the base of the power tower on the deck.
As the operator energizes the switch to hinge the tower forward
visually monitor the port and starboard deck to ensure all passengers
are clear of the hinge mechanism. is same procedure applies for
lowering the mechanism to the cruise position.
e Power Tower features an actuator
control box. is component is located
in the sump (bilge). e unit provides
over current protection through a set
of breakers on the face of the actuator
box. Facing the box the left reset
breaker protects the port power tower
li actuator. e center reset breaker
protects the starboard power tower li
actuator.
e far right breaker protects the entire circuit wiring. If the Power
Tower fails to raise check the box for an “open” breaker. Always nd
the cause of an open breaker situation before resetting the device. For
further information, refer to earlier pages in this chapter.
To Next Page
Loading...
